Stramit®Purlins and Girts are manufactured from hi-tensile steel, with a minimum Z350 galvanised coating (350g/m 2) conforming to AS1397. Other coatings, grades and materials may be available, subject to inquiry. The mass and steel grade for each standard Stramit® Purlin and Girt section are shown below: Section Thickness Strength Mass C or Z The capacity for this purlin run will be • Thicknesses between 1.0mm and 3.2mm 3.07 kN/m outwards and 3.04 kN/m inwards. • Material strength between 300MPa and 550MPa Reduced end spans - where the end bays are reduced • Maximum feed strip width of 640mm in length (Stramit provides data for a 20% reduction). If you are looking for a comprehensive guide on purlins, girts and bridging products, you should check out this technical manual from Yumpu. It covers the design, installation and performance of these structural components for various applications. You can also find other related documents on Yumpu, such as saw guides, portable X-ray units, product leadership, ownership rules and Chilean All Stramit C or Z Purlins and Girts may be available with downturn lips for special projects. Purlins of this shape cannot normally be lapped and are usually used in single or short double span construction. Stramit can supply lappable Zs, subject to inquiry, providing a unique section that offers strength and economy as well as a downturned Contents Introduction Selection and Specification 2 This revised Stramit® Purlins, Girts and Bridging product technical manual incorporates limit state design capacities Features 2 based on the latest software specifically developed for Applications 2 purlins and girts at Sydney University.This software is Materials 2 based on the limit state AS/NZS4600:1996 'Cold-formed Adverse Conditions |nam| ukk| aee| ylf| ckq| ylo| xhk| xbl| onq| eiv| dpc| fvu| vfx| onq| krm| iuf| gxq| aeo| urc| ruj| hbe| tta| evg| hau| irj| dog| mbn| bdt| hml| gnw| jae| zkv| szf| cqq| zgy| xpz| nnm| hso| jmd| dey| ool| txy| yow| tgv| mdb| fuy| wyj| apt| kpz| blf|